Control file listing for: Nippon Super Gemini (small spacing)
- # *** Embosser definition unchanged since 03/31/2011
- # Because of the small spacing. interpoint is not possible. Use (Nippon Telesoft Gemini) for interpoint.
- # Using Proprietary driving sequences. similar to 55
- # Proprietary control sequences used for this embosser
- # Warning -- page size maximum needs to be compiled into driver source code
- # Notice the use of Customize for small line spacing
- # Customize = 2 -- small spacing 235/900 inches/line
- # Customize = 3 -- middle spacing 274/900 inches/line
- # Customize = 4 -- large spacing 314/900 inches/line (command not needed. large is the default)
- # Customize = 5 -- unsure if this is a valid spacing
- # Customize = 6 -- ST spacing. exact spacing depends on page size
- Driver = "Emb_Gemini_EmbosserDriver"
- SubModel = 1
- StartLeftMargin = 0
- Interline
- Customize = 2
- MaximumCells = 32
- MaximumLines = 24
- NarrowWarning
- NoLeftMargin
- NoRightMargin
- NoTopMargin
- YesUSB
- HelpPage = "Nippon_Super_Gemini_(small_spacing).htm"
- Form "10_n" = 85 x 100 ; SinglePage;
- BrailleOnly = 32 x 22 ; 32 x 22 ;
- Interline = 32 x 22 ; 32 x 22
- Form "11_n" = 85 x 110 ; SinglePage;
- BrailleOnly = 32 x 24 ; 32 x 24 ;
- Interline = 32 x 24 ; 32 x 24
- Form "11_gem" = 100 x 110 ; SinglePage;
- BrailleOnly = 32 x 24 ; 32 x 24 ;
- Interline = 32 x 24 ; 32 x 24
- Form "12_n" = 85 x 120 ; SinglePage;
- BrailleOnly = 32 x 26 ; 32 x 26 ;
- Interline = 32 x 26 ; 32 x 26