The Elekul 03 has a serial port. Use a straight through cable to connect the PC with this embosser.
Serial Port Settings: The recommended baud rate is 4800 baud. Set this speed using a DIP switch on the embosser. The Elekul is always set for 8 data bits, 1 stop bit, and no parity.
The Elekul 03 has three separate versions of its ROM. One has the USA table, one has German, and one has Russian. To work with this software you need the USA version. Even if you are not making North American braille, you need the USA version of the Elekul in order to work with this software.
You must use a serial connection to connect to the Elekul 03.
The phone number for N.V. Interpoint is +32 16-20-1230.