Control file listing for: Nippon Gemini (small spacing)

• # *** Embosser definition unchanged since 08/06/2004
• # Because of the small spacing. interpoint is not possible. Use (Nippon Telesoft Gemini) for interpoint.
• # Using Proprietary driving sequences. similar to 55
• # Proprietary control sequences used for this embosser
• # Warning -- page size maximum needs to be compiled into driver source code
• # Notice the use of Customize for small line spacing
• # Customize = 2 -- small spacing 235/900 inches/line
• # Customize = 3 -- middle spacing 274/900 inches/line
• # Customize = 4 -- large spacing 314/900 inches/line (command not needed. large is the default)
• # Customize = 5 -- unsure if this is a valid spacing
• # Customize = 6 -- ST spacing. exact spacing depends on page size
• Driver = "Emb_Gemini_EmbosserDriver"
• StartLeftMargin = 0
• Interline
• Customize = 2
• MaximumCells = 32
• MaximumLines = 24
• NarrowWarning
• NoLeftMargin
• NoRightMargin
• NoTopMargin
• YesUSB
• HelpPage = "Nippon_Gemini_(small_spacing).htm"
• Form "10_n" = 85 x 100 ; SinglePage;
• BrailleOnly = 32 x 22 ; 32 x 22 ;
• Interline = 32 x 22 ; 32 x 22
• Form "11_n" = 85 x 110 ; SinglePage;
• BrailleOnly = 32 x 24 ; 32 x 24 ;
• Interline = 32 x 24 ; 32 x 24
• Form "11_gem" = 100 x 110 ; SinglePage;
• BrailleOnly = 32 x 24 ; 32 x 24 ;
• Interline = 32 x 24 ; 32 x 24
• Form "12_n" = 85 x 120 ; SinglePage;
• BrailleOnly = 32 x 26 ; 32 x 26 ;
• Interline = 32 x 26 ; 32 x 26